West Lake Forest Animal Hospital

Location: 999 Sherwood Dr. Lake Bluff, Illinois

Architect: Linen Group
Contractor: RWE Management Company

Scope of work: New Masonry

Furnish, set-up, maintain, dismantle and remove all equipment (tube scaffolding, ladders, hand tools, etc.) necessary for the new masonry portion of the project.
Furnish and install thin stone veneer as per drawings (approx. 300 S.F.) (one (1) tower). Thin stone to be as per below allowance.
Installation to consist of covering substrate with one (1) layers of felt paper, fastening metal lathe over felt paper using galvanized screws/nails (1 screw/nail/staple per square foot minimum), applying scratch coat and lastly thin stone. Mortar to be natural gray type “N” mortar.
Once thin stone has set all stone joints to be grouted and tooled to final finish using natural gray type “N” mortar.
Furnish and install weep screed at the base of new thin stone if necessary.

Furnish, set-up, maintain, dismantle and remove all equipment (lifts, tube scaffolding, ladders, hand tools, etc.) necessary for new E.I.F.S. portion of the project.
Furnish and install approximately 500 S.F. of new E.I.F.S. at the exterior top of the building as per drawings (plus 6” return at storefronts). E.I.F.S. to be StoTherm Essence System® (or equal system).
Furnish and apply Sto Gold coat air and water barrier over substrate as necessary.
Furnish and apply 48” standard mesh over previously rasped insulation board (9 ½” at termination points) and fully embed mesh into wet base coat (Sto 101 PAB) by troweling from center to the edges of the mesh (double wrapping mesh at all corners).
Furnish and apply finish to base coat using trowel to scrape material down to a uniform thickness. Finish color and texture to be selected from Sto standard chart.
Installation of aesthetic accents, (trims, quoins, cornices, V-grooves, drip edges, etc.) per drawings.
Furnish and install caulking in those areas where E.I.F.S. butts against dissimilar material as per drawings (metal, masonry, wood, etc.). Caulking to consist of installing 3/8” backer rod and filling with a one-part silicone sealant (Tremco® 3 or equal).

Previous Project Next Project